Neil Voss, Researcher on Competitive Copy-Cat
Machines
Competitive machines excel at making the water dirtier and causing
people to focus on what is in the water. Copycats promote maximum
creation of electrolytic precipitation of dissolved solids, electrode
action, pollutants and additives in the water, affecting the color
of the water. Our focus is on increasing energy by patterning the
field of energy to balance, harmonize, and elevate the bioenergetics
of the individual.
1. Competitive units create static energy that is one directional
as apposed to the Q2 that creates dynamic, interactive energy.
Static energy is an abundance of stationary electrons in the water
while dynamic, interactive energy is moving back and forth energy.
They show a picture of the aura in their brochure afterwards, but
they don’t show any change in the aura or colors of the aura
before and after. Static electricity also creates more chlorine,
and cell membranes are susceptible to heavy chlorine.
2. Competitive units do not have Underwriting Laboratory approval,
nor are they registered as a Medical Therapeutic Device. Safety
is a big issue when you are dealing with electricity and water.
Our unit meets strict international safety guidelines for all countries
around the world. The Q2 was tested under pressure for one hour
with fire hoses coming from several directions. You probably could
virtually drop the unit in water and it would not hurt you. This
is not recommended.
3. As a result, without Underwriting Laboratory approval, they
are unable to obtain Liability Insurance. If there is a problem,
good luck.
4. They use colored acrylic plastic that generates more chlorine
from its base in the water. The competitive units look crude inside
like they were made in a garage.
5. Wider and thicker positive tracks are on copycat units, creating
a different energy, giving different frequencies and different
results. If the frequencies of the unit are out of phase with the
frequencies of the body, the result can cause the amplitude of
the frequency to have a destructive frequency in the body systems.
6.
Wider and thicker negative tracks on their units cause the copper
ring to wear out faster, as well as creating different energy,
giving different frequencies and different results. Problems
may be caused in the body from static, insensitive frequencies.
7.
Nylon housing materials on their units create an increased number
of pollutants in the water, giving it more color.
8. The lon Cleanse
[copy-cat unit] uses vertical plates that get very rusty even from
the first use. This rust is heavy oxidation
and shows signs of a low-grade stainless steel. Hence, the water
picks up the rust and creates redness in the water that doesn’t
come from the body. The plates have to be sent in to the company
to be changed quite often. I am told it costs about $70 each
time.
9. There is a tuning fork effect from the combination of
metals in the array. If this is altered, it alters frequencies
needed
by body systems. Competitors use low-grade metals. The Q2 has
some rare metals to give correct frequencies dynamically tuned
to body
systems.
10. Competitive companies use power supply components
and parts from the shelf, which are designed for static systems,
causing
electricity to flow in one direction only. These units block
the returning frequencies to the power unit, making their systems
static
and not interactive. Parts off the shelf are cheaper quality
and poorly constructed and create noise and interference for
the pure
signals needed by the body systems. The Q2 is not simply electricity,
but creates rather a dynamic field. Static electricity also creates
more chlorine, and cell membranes can be susceptible to heavy
chlorine.
11. Competitive companies have created an astonishing
visual for luring unsuspecting customers into buying the company’s
product. The sales demonstration is based on what you see in
the color of
the water. The customer is misled by bogus explanations of what
the color in the water means. The Federal Trade Commission has
outlawed the practice in most states.
12. Positive and Negative
Ion Production: The “Ion Cleanse” claims
to adjust the amount of positive and negative ions in the water.
This is electro-chemically impossible. As long as both positive
and negative electrodes are in the same body of water there is
always a net neutral charge in the water. For every positive
ion created, there is a negative. When they claim to alter the
number
of positive or negative ions, they are simply changing the polarity
on which an electrode is positive or negative at a given moment
and then it becomes neutral in the water. As a result, you can
change the colors of the water, but you are not getting toxins
from the body.
13. “The cheaper metal discs create distortion
and wrong static frequencies. The rings must be harmonically
balanced and
the lip on the disc creates the signature patterns in the water.
It creates fields of energy within a symbiotic loop, returning
to the power unit, which creates harmonic resonances more coherent
to the body’s form of resonance with greater energy flow.” Terry
Skrinjar, Q2 inventor.
14. The truth about the colorations in
the water is that they are created by the electro-chemical reactions
from the materials
in
the electrodes. The unit [Ion Cleanse] uses a copper winding
that terminates with a zinc electrode, and a steel tube as the
other.
When the copper/zinc electrode becomes the positive it will create
greens and blues along with black material from the copper and
zinc. When the steel is positive, it will create yellows, oranges,
and browns. It will not be detoxifying the body properly.
15.
To understand how delicate the frequencies are to the body, conventional
science teaches us that water is two parts hydrogen
and one part oxygen. Is it true? Maybe not.
16. An original experiment
placed two copper electrodes into the water. 110 volts was applied,
and the gases collected were
2 parts
hydrogen and one part oxygen by volume. However, if you use different
metallic electrodes (as competitive units have done, particularly
the ION CLEANSE), you will get different gases every time. Also,
if you increase the voltage or lower the voltage you will get
different gases. Thus if just a few little things are changed
(like copy-cat
machines have done), the extent of the energy benefits created
for body systems will be lessened and can even do harm to the
body in the long run because of wrong frequencies.
17. If the
practitioner chooses to set the Ion Cleanse at the beginning of
one polarity cycle of water, in 17 minutes and 1
second the
polarity of the water will have reversed itself and the client
will have the opposite polarity. After seventeen minutes and
one second it will change again. What use is there for setting
the
polarity of their unit?
18. Competitors do not know the secret
of continuous on and off pulsing. This pulsing makes the Q2’s
benefits to the body system very effective. The Q2 has no right
angles to the wave
forms. Competitors use a square wave form that creates a static
energy.
19. Competitive units do create limited benefits for clients
from a static charge, which creates oxidative reduction factors.
But
when the oxidative reduction factors (ORP), which relate to correcting
free radical damage to the cells and DNA are measured, the Q2
has demonstrated up to 10,000 times more ORP than any of the
competitive
units.
20. The competitive units have an adjustable voltage control.
We looked at this in our units initially, but the switch creates
too
much electrical “noise” within the circuit leading
to interference and a degradation of the resultant field energy.
21.
There have been reports by analysts that the competitive units
cause the body to dump valuable minerals and particularly
calcium
out of the body because the frequencies or the wave form of
these competitive units hit the frequencies of calcium and minerals.
Michael Stern, President of Q ENERGYspa North America, on the Imitators
of the Q ENERGYspa
The Aquadetox is a knock off of the BioCleanse, which is now sold
as the Ioncleanse. It was created by a former distributor of ours,
who partnered up with someone that has a history of knocking off
others’ technology. This unit is nowhere in the same league
as our technology.
There was a long ongoing conflict between our company and this
distributor prior to this. He insisted on selling the units by
way of telling people that the water color changes were the result
of toxins going from the body into the water. After a year of constant
battling and having to deal with the resultant crisis management
as people either bought a unit and used it in good water, which
stayed clear, making them think the unit was not working; or worse,
they would put the array in the water, turn it on, get distracted,
and come back to find the “toxins” in the water with
no one present. They would then demand their money back claiming
that the unit was fraudulent.
The Biocleanse and all the subsequent clones are designed to maximize
the electrolytic precipitation occurring in the water. That is
to maximize the drama of the “toxins” in the water.
What they are actually maximizing is the amount of corrosion of
the electrode materials into the water and their subsequent electrochemical
reactions and precipitation with dissolved materials in the water.
In fact, they routinely add salt to water, even where the water
is already highly conductive, to accelerate the corrosion process.
They also claim that they control the amount of positive or negative
ions that are in the water and that the practitioner should determine
kinesthetically what the client needs. First off, they are not
altering the quantity of positive or negative ions. The amount
of positive and negative ions when two electrodes (one positive
and one negative) are placed in a common body of water is always
the same...that is a net neutral one positive for each negative.
What they are really doing is changing which electrode is positive
at a given time. This makes no electrolytic difference if the materials
of the electrodes are the same (i.e. both the same metal). However
if they are different it will determine which metal ion is the
positive and direct the subsequent chemical reactions. Obviously
this all has little to do with releasing toxins.
In my opinion, to claim that the material in the water are toxins
and even worse to identify specific conditions with colors (i.e.
white material on the surface is Candida) is tantamount to outright
fraud.
Early on I did several laboratory tests to check if there were,
in fact, toxins going into the water. I found NO evidence at all.
What is found in the water can be explained by the electrode metal
constituents and the impurities originally dissolved in the water.
I have seen “reports” these people use as evidence
that there are toxins in the water, but everything I saw was poor
science. That is, there were no adequate controls. In this case
one would need to test the water before the array session, the
water after the array session WITH NO ONE IN IT, and water after
the array session with someone in it. In every case all I saw was
a before and after, no water without person but using the array
control. All the purported heavy metals that increased most likely
can be attributed to impurities in the electrode metals corroding
into the water.
You can see that I have little regard for these products. So,
why do people get ANY positive results? The reason has to do with
what the true nature of this technology is all about. The purpose
of this technology is to create the perfect environment for water
to convert electromagnetic energy formed around the active array
into a bio energy field. Water has the natural ability to do this
given the optimal conditions. This is what is occurring in bodies
of water that are famous for their healing powers. In those water,
the local conditions - geological, geographical, and other unknown
factors - allow the water to convert local magnetic fields, thermal
energy, or kinetic energy (motion) into the bio energy.
The bio energy that is haphazardly created by these devices attempting
to “draw toxins” is a byproduct of mixing DC electricity,
stainless steel and water. What is NOT happening is the creation
of a coherent, purposeful bio field [as in the Q ENERGYspa].
Our contention is that providing the bioenergetic resources and
the coherent field, allows the body’s own innate intelligence
to use the energy resource as it sees fit, and the coherent field
allows greater information access to the person’s core bio
signature. This is very much an energetic process.
That is not to say that there are NO physical effects that may
be beneficial from knock offs. The one thing that some have focused
on is that there is a dramatic decrease in the ORP (oxidative reduction
potential) of the water. ORP, or REDOX, measures traditionally
the availability of free electrons. The reading is with an ORP
meter and electrode. The measurement is in mV. A positive mV reading
(i.e., +1 to +800 mV) means that the water is reducing, that is
that there are electrons to contribute. The long and short of it
is that antioxidants do exactly that: they contribute electrons
to quench, or neutralize free radicals.
Now the ORP scale is semi logarithmic. That means that the differences
are much more between values than the simple numeric amount. In
the case of ORP, I believe that an amount of ~53 mV represents
an order of magnitude (a factor of tenfold). So this means that
if two readings are 106 mV apart that the difference is 100 times,
not just the 106 value. Now to put it into perspective, at least
here in the states, the tap water is usually between +400 to +500
mV. That means it is very oxidizing (maybe as a result of added
chlorine). Water in renowned healing type locations is ~-200 mV.
So we are talking a difference of 600 to 700 mV, which is a difference
of 10 to the 12th or 10 to the 14th, or one trillion to 100 trillion
times! The water measured in the Q bath is –400 to –500
mV or an additional 10 thousand to one million times!
As a footnote, the water that I have measured from the Biocleanse
and other knock off’s is between –100 to –300
mV. Even at –300 mV the difference compared to –400
to –500mV is one hundred to 10,000 times